Titanium Brazing, Inc.

Our company manufactures Ti-based, Zr-based powdered, and Al-Mg-based wire brazing filler metals for joining titanium alloys, titanium aluminides, refractory metals, graphite and carbon-carbon composites in various applications including heat exchangers, honeycomb structures, compressor vanes, tubing, electronics, X-ray medical devices, etc.

1. Low-erosion filler metals for brazing titanium alloys and titanium aluminides
2. Heat-resistant brazing filler metals
3. Low-temperature filler metals for brazing thin-wall titanium articles

TiBraze® brazing powders and wires provide extensive manufacturing advantages due to low brazing temperature, as well as performance advantages due to high-temperature strength of brazed structures.

OUR PRICES ARE DEFINITELY THE LOWEST ON
THE MARKET TODAY, ESPECIALLY FOR SMALL ORDERS.

We also provide consulting both in the manufacture and R & D projects aimed support of existing production line or prospective developments.

News

Please check out 9 new articles we have just published here .

August 29, 2007

New Product: Powder Foils For Brazing Titanium And Ceramics

Our company is supplying powdered foils 0.020 in. (0.5 mm) and 0.030 in. (0.8 mm) thick, width up to 6 in. of the following titanium brazing filler metals:

See details here >>

October 18, 2006

Amorphous Tapes For Brazing Titanium And Ceramics

Our company can supply amorphous tapes 30-40 µm thick and 40-50 µm thick, width 0.8 in. of the following titanium brazing filler metals:

See details here >

September 25, 2006

TiBraze1200

We continue the study of brazing ceramics using our heat-resistant brazing filler metal TiBraze1200 (Ni-27Ti-10Al). A composite filler metal containing 70 wt.% of TiBraze1200 and 30 wt.% of Ti-30Ni eutectic alloy powder was tested for brazing alumina ceramic in dry argon at 2084-2100oF (1140-1150oC) to improve spreading of the liquid filler metal inside of the brazing gap. Both wetting of ceramic and spreading along the large surface were improved due to early melting of the Ti-Ni eutectic.

July 5, 2005

TiBrazeAl-650A

Development of the low-temperature filler metal TiBrazeAl-650A designed for brazing thin-wall titanium articles and titanium matrix composites is completed. The filler metal has a composition (in wt.%): Al-2.5Mg-(0.2-0.3)Cr. It is supplied in the form of foil 0.03 in. (0.8 mm) and 0.062 in. (1.6 mm) thick.

May 16, 2005

TiBraze1200

Our heat-resistant brazing filler metal TiBraze1200 (Ni-27Ti-10Al) was tested for joining alumina ceramic. Brazing was carried out both in vacuum and dry argon at 2100oF (1150oC). The filler metal exhibited good wetting and brazing ability when it was applied at the entrance of brazing gap. If the filler metal is applied into the gap, the joined ceramic parts should be slightly compressed.

March 8, 2005